In case of damage to the Hall effect sensor, always check the ignition coil and the ignition cables before installing the new Hall effect
sensor. If the ignition coil has dents or cracks, replace it.

Here are the measured values for the ignition coil and the ignition leads: Ignition cables with connectors (approx. 6-8 kOhm)

ignition coil ( Kl. 15 and 1 approx. 0,5 - 0,8 Ohm , high voltage outputs approx. 7 - 13 kOhm)

replacing the hall effect sensor you should also replace the poly belt
to the alternator. These are also available in the shop.

When replacing the hall sensor, the ignition must be statically adjusted. A special device is required for this. also available here.

All our Hall sensors, cables and insulations are at least 1 level higher quality than series

If you are not sure which component fits into your machine, here is the link to the online catalogue.

After entering the VIN number you can search for it:

Boxer R 4-V/Oilheads

Sort by:
Fuel Injector, Orig. BOSCH for  BMW  1100__ and R  850

Fuel Injector, Orig. BOSCH for BMW 1100__ and R 850

(1 piece(s) = 63.36 €)

126.72 €

In stock
O-Ring for EV-14 injector

O-Ring for EV-14 injector

(1 piece(s) = 1.22 €)

1.22 €

In stock
Mot-Test Diagnostic Tool

Mot-Test Diagnostic Tool

53.61 €

In stock